I threw out this American Plimber inline filter:
[]
[]
It was over a decade old, and yes I can replace it, but I'd rather use this HDX one:
[
[
I have a torch and a hacksaw. I have plenty of slack in my copper line. I have the following collars and fittings:
[
[
[
Is the best thing to do just to saw off the plastic couplings and then soldier on the metal ones?
Best Answer
I was able to take off the plastic connectors on each end of copper. After that I realized since ther were push to connect then I could use push to connect on copper as well as flex line. At that point I cleaned the copper ends with a green 3m scouring pad, and installed the filter with no soldering and none of the brass parts.