I have a Delta single-handle faucet. I installed a conversion kit about half a year ago to update its trim from a knob to a lever. It's been great until yesterday when my wife complained that no matter how she maneuvered the lever, only scalding hot water was coming out of the faucet.
I took the assembly apart and discovered that the post which connected to the conversion ball was loose:
I tried tightening the post by hand and even with a wrench, but it quickly came loose again once it experienced the torque of the lever.
I checked with local plumbing supply stores and they don't carry the part. I'm wondering if I can fix it temporarily (for a week, say) while we await the new part. The post is secured to the ball via a short thread. Perhaps there's a suitable thread locker for this application which can withstand the torque and water? I tried JB Weld but that failed miserably. Both the post and the ball are made of steel.
Best Answer
I am sure that this can be fixed with a thread locker material. There are products available that can be placed onto threads before assembly and then will cure into a very tight joint to keep the threaded fasteners from coming loose.
You can get this at almost any auto parts store. Ask them for "loctite" thread locker.
Before trying to use it clean out the threads in both the ball and on the stem piece. Since you already attempted to use epoxy on these parts it may require extra diligence to clean out the thread grooves. Wash the parts in something like rubbing alcohol and then let dry well before applying the thread locker and reassembling.
Let the locker fully cure before attempting to put torque on the stem and ball assembly.
(Note that I have no affiliation with the LOCTITE brand other than a user).