I have one cold water source, the pipe looks like this:
I would like to connect two of these pipes this the source:
How do I do this?
The best I could find was something like this. But the connectors are too narrow for the pipe, and the tap needs to be in a Y shape ideally, so that both pipes connect roughly horizontally.
Best Answer
Isn't that a garden hose size fitting? You will find the fixtures you need in the garden department of a lumber store. Many people use a Y-joint to connect two hoses to one bib. These come in plastic or brass; get the brass.
From the picture it appears there is not room to screw on a Y-joint. You may need a gooseneck extension.
If a gooseneck doesn't provide the clearance, or if you can't find one, you may have to make an extension. Buy a male and a female clamp-on hose connector, cut one foot off your garden hose, use one clamp-on to make the extension, and use the other to repair your hose.
The best way to avoid dripping is to make sure the male ends are smooth, without nicks or burrs.