Plumbing – Is tape an effective way to hold on a foam elbow

I live in Canada and there are only two ways to stop your spigot from freezing in the winter. The first is to have a cut off inside your house, lower then the spigot and it has to have a relief valve on the exterior side to drain the water away from the wall. The other way is a frost spigot that extends about 20" into the warm zone on the inside of the wall. This actually has the shut-off all the way into the house. These have to be installed with a slope towards the faucet end so when you close it the water drains out the spigot.

Those are the only two ways to truly and confidently stop your hose spigots from freezing.

Spray foam insulation is a petrochemical product that is mixed on-site and blown with a blowing agent. The actual process is not great for anyone's health, which is why applicators wear protective suits. It is also exothermic, and if done incorrectly can cause a fire (rare). Additionally, if mixed incorrectly, or even in a small percentage of cases, the foam will offgas nasty stuff for a long time, rendering the house uninhabitable. I must stress that these cases are rare, but they do happen. Furthermore, fully-cured spray foam is flammable at elevated temperatures and will char and emit smoke at typical household fire temperatures.

Are there better insulations out there than spray foam? Absolutely. Spray foam is about the most expensive insulation you can get, and it is terribly mis-used most of the time, applied where its benefits are wasted. For insulating walls between stud cavities, wet-sprayed dense-packed cellulose, sprayed fiberglass (under the brand name "Spider") or mineral wool batts are better choices. For turning an attic into conditioned space, installing rigid foam boards above the roof sheathing is the preferred approach if already re-roofing. If that's not an option, then you can fill the spaces with the aforementioned choices of cellulose, fiberglass, or mineral wool batts, as long as you 1) create a ventilation channel of 2-4 inches in the rafter bays below the roof deck, 2) install a ridge vent and soffit vents that allow every rafter bay to be ventilated, 3) use an interior-side smart vapor retarder membrane such as Intello MemBrain (note: NOT a vapor barrier like polyethylene sheeting), and 4) you finish the assembly off with drywall, being careful to make the drywall layer as airtight as possible. Alternatively, you can detail the vapor retarder membrane as an air barrier and skip the drywall or use non-airtight finish materials like tongue-and-groove pine boards or something.