Plumbing – Is the bathroom wet-venting plan reasonable

A shower drain needs a trap, so check under the cap on the left to see if there's a trap or a straight drain. If it's straight, then your assumptions are likely right that it's a toilet and the other one is a clean-out (fix that cap, you don't want sewer gases getting it). If you don't have a shower drain here, then I'm guessing it's only roughed in for a half bath.

I don't imagine the 2" would be anything other than a vanity drain.

With the "vent," I'm left wondering if it's really a drain since I see a clean-out installed on it. I'd recommend tracing that line up the walls, as best you can, to verify it really is a vent.

As for where the horizontal line is going to the left, perhaps a washer dryer, or perhaps the plumber screwed up the T and it should be pointing to the right for the sink. It's hard to tell from here.

You must have a vent. The toilet will not flush properly without one, and there will rarely be enough water left in the bowl. You need a 2" vent to take off from the branch line within 6 feet of the toilet. It can run up any convenient wall until it is above the toilet's flood level. Then it can run near horizontally (1/4" per foot) anywhere to tie into an equal or larger vent.

There's any number of ways to properly vent a toilet, and several common ways that are technically wrong, and even more that are just plain wrong. It's impossible to suggest a good method without a lot more information.