Plumbing – Outside hose bibb with very fine thread

You branch off from the copper tubing with a 1/4" compression tee. Cut out a small section of tubing for which the tee replaces. You must use a tubing cutter to do this, any other method will cause the tube to become oval.

Install the short piece removed on the side outlet of the tee. Attach a 1/4" compression x 1/2" pipe thread adapter to the short section. If you can find a tee with a pipe thread side outlet (preferred), skip the previous step.

Connect a 1/2" pipe thread to hose adapter. When buying parts, ensure the male and female parts mate correctly. If you can't find the proper mates, get a short nipple or coupler to change gender. Use several layers of teflon tape on male pipe threads, wrapped in the direction that causes it to get more snug when the pipe is screwed in.

Attach hose and controller. After all this, there probably isn't much pressure left, meaning you could probably transition from hose to 1/4" drip fittings for the run from controller to plants, keeping the installation less obtrusive. If you use pressure adaptive drip fittings, you can better regulate the flow to each plant, otherwise the first plant will get the most water, the last hardly any.

Be careful, though unlikely in this case, as high pressure can cause drip fittings to blow apart. You also can't use most pressure reducers, as they can spill water as they function. You'll probably have to go from hose to 1/2" drip main to 1/4" drip distrubution. The 1/2 to 1/4 punched connection can leak slightly, so it should be done over the first plant.

For most threaded connections, first hand-tighten and then using a wrench, tighten in quarter-turn increments. If it leaks, give it another quarter turn. You shouldn't need excessive force with a wrench to tighten it.

For anything other than compression fitting, use Teflon tape and/or pipe dope on the threads.

Make sure that it is not cross threaded. If you need excessive force from the beginning, there is a good chance you have cross-threaded it (assuming the correct thread type).