Plumbing – Recommended way to bolt toilet tank

Thanks for the comments getterdun and bcworkz.

I went to Toolstation and bought a new service valve and also a new inlet valve for the princely sum of about £11. As per your suggestion I checked the plastic pipe, and it looked a bit rough around the end and one of the teeth of the thread was badly worn, but I couldn't see a way to replace just the pipe so I replaced the whole thing (dismantled the cistern and everything as per a video on YouTube).

I couldn't get the old service valve off, couldn't get enough grip to turn the valve part opposite to the nut part, so I decided to leave the old one now but give it a really good wipe and test anyway with the new inlet valve and pipe. I also used a fresh fibre washer. At first when I turned the water back on it leaked quite a bit and I was slightly disheartened, but I remembered reading somewhere that fibre washers slowly expand as they get wet, so I just put a bucket under the leak and left it for an hour or so. Bingo! No more leak :)

That's most likely iron rust deposit, easiest thing is to ignore it; you aren't going to be drinking from the bowl anyway.

Otherwise turn off the feeding valve flush again to drain and start scraping.