When I turn on the hot water in my shower there is a loud clunking sound. I'm afraid the vibration may cause a joint to loosen and leak. Any idea as to why this is happening and what I can do to correct it? The house is 57 years old and I think the plumbing is original. Thanks.
Plumbing – What could cause a loud clunking sound when I turn on the hot water in the shower
plumbing
Related Topic
- Plumbing – Loud noise in the pipes when I turn off the hot water
- Plumbing – Funny “thump” sounds sometimes at night, what could be the cause
- Plumbing – Loud vibration using hot water
- Plumbing – Water gets really hot after 2 minutes in the shower for 5 minutes then goes normal
- Plumbing – What could cause the hot water to run out quickly… but only in the bath/shower
- Tankless Water Heater – Why Pressure Relief Valve Releases Water
Best Answer
Sounds like a classic case of a "water hammer".
http://en.wikipedia.org/wiki/Water_hammer
If you have access to the feed line anywhere (even in the basement) you should be able to confirm the hammering by placing a hand on the line when someone else turns on/off the faucet. You will feel the line kick at the moment you hear the sound.
One fix is to install a cushion (foam, rubber, etc) around the pipe where it makes contact with the joist or nearby wood, or add additional hangers onto the pipe to prevent the line from moving freely. It's also possible to install a "hammer arrester" which contains a small diaphragm which prevents the water flow from stopping suddenly.