I was doing my annual dryer maintenance, when I noticed that the main dryer vent line has fallen off. Looking to reconnect without putting a large hole in the floor.
In detail:
We have second story laundry with a 19' rigid dryer line to the outside.
There is ~60° bend where the line was attached to another flanged rigid piece (about 1') which was mounted to the floor.
From there there is a short Al flexible connection to the dryer (a 12" rigid pipe out of the back of the dryer).
When I disconnected the flexible portion, I noticed that the rigid piece in the floor opened up to the sub flooring as the line to the exterior had fallen off.
I was able to pull the piece in the floor out, and expanded the hole slightly to be able to manipulate the the exterior line. I put in a brace to hold it up (which was hard) but I really can't get a hand plus the rigid pipe in the hole.
There are joists about 6" apart limiting horizontal expansion of the hole, but I could continue to expand it vertically (not that I really want to cut through the subflooring).
Are there any tools, tricks, or special connectors that would make it easier to reconnect the line?
It was originally done during the construction of the house before the 2nd story flooring was put in.
Photos:
Best Answer
Ah, how I hate people who build things designed to last forever, or rather to need the house ripped apart when they don't.
I'd try a loop of wire (galvanized steel or aluminum, whichever the duct is, so they don't corrode each other over time) wrapped around the pipe in the hole to allow you to pull on that while shoving the stub pipe into the elbow. Look down through the stub so you can see what you are doing. Attaching that wire to the stub would then hopefully keep the elbow from falling off again. You would need to seal the joint with duct seal since there's no way you can tape in there.
Alternatively, figure out where the access panel for this job should have been put, buy an access panel, cut a hole in the ceiling (below the pipe), and put the access panel there. Or do what too many folks do, and simply cut a hole in the drywall, convince yourself this will never happen again, and patch the hole in the drywall.
If you are having trouble mating the male and female bits, bend the male bits inward a bit more than stock.