What's the name of the 'rubbery' sealant they use between the bath and the wall, and why don't they use it in between the wall tiles? They use a hard grouting between wall tiles, but if the weight of the bath water makes the bath slightly drag the tiles down when it is filled which may crack the grouting (presumably why they use the rubbery sealant between bath and wall), isn't it more sensible to use that rubbery sealant for all the grouting?
Sealant used to prevent water getting between bath and wall
bathbathroomcaulkinggroutsealing
Related Topic
- Shower – How to repair a shower corner bench
- Shower – re-grout if there is possibility of mold/mildew behind shower
- Shower – Should I use caulk to fix cracking grout in a shower
- Flooring – Groutable vinyl tile in a laundry room. Is it a bad idea
- Tile – Removing grout with oscillating tool: too narrow/too high
- What to use between tiles and door
- Flooring – First time DIY tile floor in powder room–transition, leveling, grout
- Walls – What material should I use to seal door moldings, small holes between walls and floors to prevent roaches
Best Answer
The rubbery sealant is bathroom (or general-purpose) silicone caulk. As to why they don't use it between every tile, the answer is that it shouldn't be necessary; except for the one row of tile overhanging the "backsplash" of a "built-in" tub (helps keep minor splashes and overflow from seeping into the wall behind the tub), all tiles should be fixed to the wall, and unless the bathtub is not properly supported from underneath the weight of water should have only a minimal effect on stretching and shrinkage of that wall. If the wall IS stretching and shrinking enough to crack and flake the grout, it will probably also be affecting the tiles' adhesion to the wall, and you will, sooner than you should have to, be paying someone else to repair or replace the tile.
It's also a cost-benefits thing. Grout is very easy to apply; after applying the tiles to the backing, simply load a trowel with the grout mix, and scrape it over tile and gap alike, pressing the grout into the gaps. Then, with a damp rag, wipe off the tile, leaving grout in the gaps. Contrast that with going over every gap between tiles with a caulk gun, carefully applying just the right amount of caulk; caulking is precision work if you want it to look good. You can grout a full shower in less than an hour; you'd be there all day with a caulk gun.