In my new place my shower is tile and has a spring loaded shower curtain rod. I have my curved rod from a previous residence and would like to mount it. I can operate a drill, but I have never gone through tile. The instructions are oddly specific stating I should use a ceramic bit at no more than 100 rpm using oil to lubricate the bit every 30 seconds.
While this seems easy enough, I'm a bit intimidated by the prospect of drilling brand new tile (installed prior to my move-in). I assume once I'm through I put in some plastic anchors and operate business as usual.
Am I missing anything important/obvious?
Best Answer
Use a masonary bit (easier to get hold of)
Put a cross of masking tape on the tile to stop the bit slipping sideways when you start
Go easy, don't put too much pressure on the bit.
Tip: try on an old bit of broken tile ( or a broken mug/teacup from goodwill) before starting on the expensive tiles.