motion-sensorswitch
I purchased a motion sensor to operate the lights in my garage. The Motion sensor has four terminals labeled LNLN. When I remove the switch, I have a Black wire, white wire, bare wire, and a RED wire which is puzzling me.
The instructions are below.
The red wire is confusing me. Thanks for your Help
2]]2
Wiring diagram for Leviton PR180 3-Way Wall Mount Occupancy Sensor.
This type of switch requires a small amount of power to operate, and since there is not always a return path available for constant power. This switch uses the grounding conductor as a current carrying conductor, and dumps a small amount of power to the grounding conductor. It's not the best design; in my opinion, but if the standards and safety organizations approve it it must be safe.
Because of this awful design, a solid connection to earth is required for this switch to function. Which in your case, seems to be missing. It sounds like there is a grounding conductor included in the cable assembly at the switch box, so I'd start by tracing the cable back to where it originates. Follow the cable back to the nearest junction, whether that be another device or the service panel. Open up the junction point, and inspect the wiring. If everything looks good at that point, continue back down the line until you reach the service panel. You can use a tool like this Multi-Purpose Wire Tracer, to help trace the line through walls and ceilings.
If you reach the service panel, and all the connections along the way looked good. It means you likely have a break or some other damage to the grounding conductor inside the cable assembly. If this is the case, you'll have to locate the damaged section and replace it.
Best Answer
Normally Black is the hot supply or L, the white is the neutral N both from the supply and to the load the red wire is the switched hot. This is how all the motion sensors work that I have installed. But you don’t show which wire is red but this is the most common. Most electricians use Red as a switched hot but it is not a requirement to do so.