In several rooms I have a wall switch near the door that switches an outlet, and a light/fan fixture operated by a pull chain. I would like to be able to switch the light fixture from the door switch, and have the outlet be always on.
What I want to do is the following:
Wire from the fixture to the existing switch (external to the wall, under a wire tunnel to minimize the work).
At the switch, directly connect the wires from the socket to each other so the circuit is always closed.
Is this safe? Is there any reason not to do it this way?
Switched socket and unswitched light fixture to switched light fixture and unswitched outlet
light-fixturereceptacleswitch
Related Topic
- Electrical – Changing garage light socket to outlet, found wiring problem
- Electrical – Is it safe to wire a light junction box to a plug (which could then be plugged into a switch-controlled outlet)
- Problem installing outlet off pull chain light fixture
- Make a switched outlet which is connected to light hot all the time without running new wire
- Electrical – Wiring Light Fixture with 2 Sockets into Junction Box with 2 White, 2 Black, and 1 Red Wire
- Electrical – How to get this light fixture to light up
Best Answer
For the socket, yes, simply take the 2 wires off the switch and splice them to each other. This will "free up" the switch for other uses.
Now if it's a split receptacle (one outlet constant-on, one outlet switched) the simple matter is to do as the above. However, inside the outlet, will be 3 or 4 wires feeding the outlet. Depending on how it's wired, it may be possible to "tidy up" by bypassing the wire-run between the outlet and the switch. How exactly to do that will depend on how it's wired, diagram it out (or snap photos) and ask again here.
To switch the fan, if your plan is surface mount conduit, that is easy. Code requires that you use proper, rated actual conduit, not the cheap wire-mold meant to guide USB cables. Run individual wires (THHN) in the conduit - and you get to choose your colors, e.g. black for always-hot, blue for switched-hot to the fan, yellow for switched-hot to the light. As implied, you can have a separate switch for each, provided your fixture can accommodate that (most can).
You will also need to wire a ground which must be green. White and gray are reserved for neutrals, and code technically requires you run one for potential future smart-switch use, but I argue, you're in conduit, it's easy to add.