The chain on a chainsaw I borrowed came off after I used it . I got in back on and it is tight but it will not go around the bar.It starts ok and the chain lock is not on.Why is this happening??
The chain came off and when i put it back on it won’t go around the bar
chainsawrepair
Related Topic
- Electrical – How to troubleshoot “refrigerator power goes off occasionally but comes back on when I cycle power switch off and back on”
- Safely felling elevated wooden structure
- Why is the chainsaw stalling
- Diagnosing a non-starting chainsaw [Makita EA7300P / Dolmar DCS7301]
- Will a shorter bar increase the chainsaw’s power significantly
- Mystery Part from Stihl Chainsaw
Best Answer
Chains do come off when they heat up if they are not tight. There are usually 2 bolts on the side of the bar. Break these loose then there will be a screw to tighten /loosen. Loosen the bar move the bar back until the chain will go on. Once the chain is on tighten the chain and rotate it by hand pulling down in the middle to check for tension. Once the guide no longer clears the bar but there is a little slack tighten the 2 bolts and you are good to go.