I have two areas of my house which are cantilevered. One is a bay area which extends about 2'. The other is the bottom of a fireplace box (gas fireplace). I have placed two layers of R-13 (I think) insulation in this area, but inside the house it's like a heat sink where all of the heat is sucked out … very cold to the touch in the winter time. Obviously there must be a better way to insulate this area.
My question is, what is the best way to insulate a cantilevered area so as to allow the inside area of the house to not be so cold in the winter time?
Best Answer
In ascending order of cost, difficulty, and expense:
Bump-outs are notoriously leaky because of their complicated construction. Seal all air leaks in the applicable areas that you can find using caulk for small holes and gaps and expanding spray foam for larger ones. Cover any exposed spray foam with drywall or spackling compound to protect it from ignition, especially near a gas fireplace.
Remove any drywall or flooring materials in the area and insulate any stud bays that are currently empty or full of crappy fiberglass insulation with far superior Roxul mineral wool insulation, then replace the drywall and/or flooring.
Remove any siding materials on the outside to expose the housewrap or tar paper over the sheathing, and cover it with rigid foam or rigid mineral wool boards and re-install the siding. Note: to do this properly, please read http://www.buildingscience.com/documents/bareports/ba-1204-external-insulation-masonry-walls-wood-framed-walls/view?topic=resources/retrofits