The new toilet I'm installing has a side to side rock(pre wax ring test) of between 1/16" and 1/8". Is the wax ring sufficient to overcome this gap? A level indicates the left side of the toilet as I face it is where the shim would need to be placed in order to stop the rocking and have the toilet remain level.
Tolerances when installing toilet
toilet
Related Topic
- Plumbing issue throughout house – gurgling coming from shower, bubbling in toilet, standing water in drain of shower
- Question about picking best wax gasket for toilet (specifically Toto)
- Plumbing – Toilet flange spacers and closet horn seal
- Plumbing – Does a toilet have to be level front to back if the toilet doesn’t rock and the flange tilts too
- How to fix water leaking past toilet bolt
- Plumbing – PVC toilet flange replacement problems
Best Answer
Install the wax ring pressing firmly all the way around the toilet. Use your level again. You can add wedges on one side by sliding them in gently. I would use more than one for stability. Don't slide them in too far or you will break the wax seal. Once you get them where you need them, tighten up the floor bolts. To finish, cut the excess from the wedges and caulk around the base.