Walls – Shower divider wall – load bearing

I see there were a few responses to this and I never responded 4 years ago. We ended up using 3 LVL's glued/screwed together and hoisted those into place. We haven't had any problems and we get multiple feet of snow each year. Here's a pic from 4 years ago when we set the beams.

You say this house "has a truss roof". If the house truly has a truss roof, the only load bearing wall is at each end of the truss. But you contradict yourself when you say “the ceiling joists meet about 12 inches to one side of the wall”. The bottom cord of a truss (what the ceiling dry wall attaches to on truss construction) would be either one piece or spliced. They also would likely be 2x4 construction on a house that small. When you say the ceiling joists meet about 12 inches from the wall, I assume you mean that they overlap each other at that point. I would dearly hope that both ceiling joists reach all the way to the top plate of the wall in question. If not, and the fact that you say the wall is not directly supported to the building foundation, it looks like poor construction practice and not meeting whatever code is in place at your location.

I just finished removing a wall very similar to what you have described. But my wall was directly in the center of the house, parallel with the roof peak, and directly over the center beam of the house. My wife wanted a smooth ceiling, (no header), so the support had to be done in the attic. I ran the calculations for a 22’ span and found out that a span that long is totally impractical. So I put a column at 13’ from one end, which I used as a pipe chase for the kitchen sink vent. With only a 13' span, I was able to use two, 1¾” by 11¼ “ LVLs in each direction from the new column that I shimmed so they were a little more than ¾” apart. Each other end was in a wall so I was able to add 2x4s as a support and block the space between the basement beam and the subfloor so that the load was transferred down to the foundation. I also had to check that the resulting point load from these new columns did not overload the basement beam. I then fabricated some steel “hangers” from 4” channel and ¾” threaded rod to catch the two ceiling joists that overlapped the old wall. The two lapped ceiling joists nested perfectly in the 4" channel, and the threaded rod slipped between the two LVLs to above a top ¼” plate that spanned the twin LVLs allowed a firm bolted connection. The ceiling joists were shimmed as required to keep the ceiling level.

So I agree with Jimmy Fix-it on the inadequacy of a 4"x8" for a 13’ span. You don’t say where you are, north or south. If you are south, you don’t have a huge snow load to worry about. But I would spend the money and engage an engineer to evaluate the current design situation, as any changes you do could exasperate the problem.