I recently had a farm sink installed in my kitchen. I noticed that the drain seems to sit slightly above the curve of the drain hole. A little bit of water also pools around the drain when the sink is used. Is this normal or does the drain need to be reinstalled to sit lower? I asked Kohler support and they said it looks like it was installed correctly, and they said it could appear slightly raised due to the plumbers puddy underneath. Most sinks I’ve seen, the drain sits below the curve of the drain hole though.
Water – Farm Sink Drain Installation
drainsinkwater
Related Topic
- Bathroom sink won’t drain
- Plumbing – Is bathroom sink pipe configuration up to code and does it have a trap
- New Sink Drain Not Aligned with Trap – How to Fix
- Plumbing Issues – Dealing with Sewage Smell from Kitchen Sink Area
- Sink Quartz – Should You Grind a Quartz Counter Top or Call a Pro?
- Unclogging sink drain
Best Answer
That does not appear to be correctly installed, it should lie flush with or below the sink surface.
These strainer assemblies commonly come with 2 ring-shaped washers; one rubber and one hard plastic or fiber. Both should be placed on the underside of the sink between the strainer mounting hardware and bottom sink surface. Neither are for "sealing" purposes. The rubber one is a cushion and the plastic/fiber one is a friction ring.
Make sure that there is no gasket of any sort between the upper strainer lip and the sink (it sure looks like there is...). The only thing between the strainer lip and the sink should be plumber's putty, and any excess putty squeezes out when the strainer is tightened (until flush with or below the sink surface) to the sink.
The only other possibilities are that the strainer has not been tightened completely down, or the sink (or strainer) is defective.