Now that it is getting colder, we have noticed that when we get home from work, our water is not that hot. It was warm at best after a four-day trip. The water heater is in an unheated basement, next to the furnace. It's not freezing by any means. After a shower or some dishes, it heats up fine and we have hot water.
It's a gas water heater. My mental image of how it works is that the fire shuts off OK when the water heats the desired temp, but doesn't come back on until new cold water is introduced. I would have guessed that it would be a normal thermostat. If it is a thermostat, how do we set the temperature that the water heater that the fire come on at?
Or, can someone explain how this works in reality, and offer advice?
Best Answer
Yes, it's a thermostat, and there is usually a dial on the side of the tank, near the bottom, to adjust the temperature. More than likely, the water feels colder because it is traveling through uninsulated pipes and is losing much of its heat before it reaches the faucet. You can turn up the temperature of the tank, insulate the pipes (they make foam insulation that just slips over the pipe, just be sure to measure the diameter of your pipes so you get the right one), or both.
You should also consider flushing out any sediment from the bottom of the tank if it's been a while since you last did this. All you need to do is hook up a garden hose to the drain at the bottom of the tank (make sure it can take the warm water), run the other end to a floor drain or utility sink, and open the drain on the bottom of the heater. Make sure the water runs clear for a minute or two before closing the drain. To save on the gas, you can set the thermostat to only run the pilot light while you flush the sediment.