In my basement I have copper water pipes that look like they hooked up to an old shower. Now they don't hook up to anything. I want to prune these pipes where they come off the main water line (so I can put a deep freezer in their place) but I've never done anything like that before.
Google tells me I have two options for pipe fittings: sweating or compression fittings.
I want something more or less permanent but I don't to buy extra tools I may not need again for a long time, plus if I can avoid open flames I'd like to, etc. Are compression caps available and suitable for this kind of thing?
PS Can I cut copper pipe with an angle grinder or should I buy a pipe cutter?
Resolution: Thanks for all the advice! In the end I went with a pushfit cap made by SharkBite:
I also bought a handheld, handleless pipe cutter for $7. I shut off the water, cut the pipe, popped on the cap, and turned the water back on. Worked like a charm. The whole job took 20 minutes and cost about $11.
I'll look forward to learning to sweat connections another time. For a casual plumber like me, pushfit fittings cost about 10 times as much as soldering and so worth it.
Best Answer
Compression caps are available and suitable, but you do need to be fairly careful when fitting them that you tighten the joint just the right amount. You also need a reasonable amount of room to be able to turn the spanner/wrench.
Soldering will give you the most professional result and can be done in a fairly confined space - as long as you take the necessary precautions to avoid scorching/burning the surroundings.
If you really can't face the thought of soldering the joints then you can get push fit end caps that work very well. You need to make sure you've got a smooth, straight end to get a good fit, so a pipe cutter is the preferred cutting method. You can use a hacksaw, but you will need to then use emery paper on the end to remove the burr.