Ok all i did was i added to the end of the hot and cold water lines about 3 feet of copper line on each hot and cold water to install a washer .I turned off the main but didnt drain the hot water heater just turned off the breaker . added the plumbing and then turned on main and turned on breaker . The washing machine works fine hot and cold water the sink near by works fine also hot and cold water . The problem is there is another bathroom near by and the sink doesnt work now no hot or cold comes out nothing . There is a toilet in that bathroom and it works fine . Why would the bathroom sink no longer get any water ( cold or hot water) .I tryed a couple of times turning main off and on again and nothing . like i said the other sink and washing machine work fine and so does toilet in that bathroom but no water at all comes out of sink hot or cold . And i never shut off angle stops below that sink i never touched it . Any help u can offer will be great thanks for ur time
Water – no hot water or cold water after installing faucts
water-heater
Related Topic
- Water – Why is there no hot water in the kitchen after flushing our water heater
- Plumbing – Low hot water pressure in one fixture after water heater replacement
- Plumbing – Why Can’t I Drain My Hot Water Tank
- Water – Hot water gets into cold water
- Plumbing – No hot water (at all) on upper floors
- Plumbing – Hot water tank cold water is always flowing
Best Answer
Remove screen on faucet and take apart and clean. May even have to pull valves on faucets and clean. During your repairs I would guess you disturbed some crud and stopped up the little water conservators in the tap. As a old restorationist I see it all the time.