Does anyone have any better solutions for dealing with my hardwood floor damage than what I describe below?
Below is a picture of my bathroom floor. Water has apparently damaged it from a toilet leak (caused by a failed wax ring which I am in the process of resealing).
Do I have the best plan for repair? Is there a better solution? (I am a DIY newbie.)
Here's what I'm considering:
-
Cut out the damaged floor area in the shape of a rectangle roughly the size of the visibly damaged area. In the photo, this appears to be about six planks wide (or 6 x 2.5" = 15"). And roughly double that width in length. So that would be a total cutout area of about 15" x 30".
-
Use a corded jigsaw to do the above described cutout. I don't currently have a power saw, so this will be my first purchase. I did some research and I'm leaning in the direction of getting a corded jigsaw instead of a circular or mitre saw.
-
But then what? Should I look to replace the hardwood cutout section with another hardwood section of equal dimensions? If so, how could I make that happen? Or is there a better (perhaps more durable and/or flexible) flooring solution? Or maybe a temporary solution that clears up the immediate problem but leaves the door open to an easy upgrade in the future? (e.g., rubber padding!?)
Am I heading in the right direction? Any thoughts, insights, opinions or advice would be greatly appreciated.
Fig. 1. Water damaged floor needs repair/replace.
Edit
- Here is the video @DanMantyla describes in this answer.
- Here is another.
Best Answer
Remove the old, rotten wood and replace it with new stuff. This is a very common repair.
I've never seen anybody use a jigsaw to remove hardwood strip flooring before but I'm sure it's been done. There's an Ask This Old House episode or two where they tackle this exact project, google it they're good videos, and Tom uses a drill with a 1" spade bit to remove as much material as possible and then uses a sharp chisel to break the piece of wood in half. This seems like good advice to me.
Once you have one strip of wood removed then the others will be a little easier to remove because the tongue and grove are no longer locked. But some of your strip flooring pieces look very rotten and you might be able to just dig them out of there with a screw driver, chisel, etc.
The last board to be installed will need to have it's groove edge chiseled into a rabbit so that it can drop into place.
Good luck!
Also, if it was me, I wouldn't cut a big rectangular section of the flooring out as you described. I would only remove the pieces that are rotten and replace them with identical pieces of the same dimensions, length and species.