Is there a way to adjust the tension on a stem for a posti-temp valve? I've taken off the handle and trim, and I don't see any way to adjust the tension.
I have a single turn handle on my bath tub. It is a posi-temp valve. The handle is difficult to turn, and I have broken a couple of the plastic handles already. I'm considering buying a metal handle. However, the plastic handles should have lasted longer, and it makes me believe the stem on the valve is too difficult to turn.
Best Answer
The stem you speak of is actually connected to the internal cartridge. I believe it may have been over tightened when installed, or it was leaking a bit and some gorilla cranked it down. You will need to remove the bezel trim, and loosen the nut that holds the shaft and cartridge. There may be two nuts. If you loosen too much, the valve will leak. Some models require a spanner type wrench to loosen. A good close up pic without the trim would help here. If you can post the exact model number, we may be able to pull up an install detail for ya.