pvc
This may sound like a stupid question (I'm new to plumbing terms), but for something like this. What diameter PVC pipe can fit into this?
For example, does this mean the diameter of the coupling itself is 2 1/2" and therefor can snuggly fit a 2 1/8" diameter pvc in it?
Or does this mean a 2 1/2" diameter PVC pipe can fit in it?
Two part epoxy works well (maybe JB weld), just rough up the pvc a bit and clean it first. How much of a load are you talking about? If it is substantial, you may have to attach the PVC mechanically to the MDF.
I wouldn't use the PVC pipe at all.
Here are some things to think about...
1) Splitting the PVC pipe in half will involve two saw kerfs that will make the re-mated halves not restore to original size.
2) PVC cement will not work well in trying to re-join the two pipe halves. That type of cement is meant to be used in tight lap type joints; not in rough butt type joints.
3) If you have to use the expanding foam you really should place the pipe parts in place and secured first and then inject the foam through one or more small holes through the pipe wall.
Overall I would suggest that you reconcept your approach to this and keep the lower portion of the walls as is but convert then to knee walls with height of maybe 40 inches. Temporarily support the beam within the current opening space. Then cut out the existing studs to produce knee wall framework. The top of this knee wall gets fitted with a good double 2x4 header. Trim the top of the knee wall with a flat trim board that is wider than the drywall on each side by some 1/2 to 3/4" and trim around the skirt of the board with a nice molding. Then set a partial turned 4x4 post on top the flat board and use it to support the beam. Finish out the top of the openings over to the side walls down to the bottom of the beam, band with drywall and finish. I think this would give you the better look and still open up the space perception. The shorter 4x4 type turned posts are much more reasonable in cost.
Excuse my somewhat less than elegant cut/paste/smear work with paint program but here is the general idea of what I am suggesting.
Best Answer
If it is what we call a standard reducing coupling then the fitting you are talking will accept a standard 2" PVC on one side and 2.5" on the other.
There are some other odd ball coupling type fittings out there but for that size of PVC they would be extremely rear.
When we have a 1" PVC coupling then it is designed to couple together two sections of 1" PVC pipe. This is basically true for all the individual sizes. P.