I'm re-screening my solar screens. I have found that a very small one is easy but larger ones present some challenges (not surprisingly).
I don't want the screen to be too loose and sag. However, if I try and make sure it is taut, it tends to warp the frame inward.
Can someone suggest a technique that will minimize this? I have thought of making some sort of jig, but all the screens are different sizes and I would rather not have to build a jig for each screen.
Best Answer
I clamped two of four sides (left side and bottom, for example) to a workbench while I was doing them. Then I worked on the side that was away from the two clamped down sides.
It's not so much about getting it taut as it is about getting it even...