I was preparing to replace a cantilevered rim joist on my house today. I bought a 2×10 treated board to replace it. I cut a piece to use as blocking and found that the board was much wider than the existing joists. I measured the board and it seemed to run wide, it was about 9-1/2". Then I measured my rim joist and another exposed joist in my basement and confirmed that the installed joists are only 9" wide.
I searched online and found that actual width of a 2×10 should be 9-1/4".
Why are the 2×10's on my house only 9"? Why are the green treat boards I bought 9-1/2"? My house was built in '88. Have the standards changed? Is there a tolerance to go along with the North American Standard lumber sizes? Did the contractor use factory seconds? I figure I'll have to rip half an inch off the new boards to match the old ones.
Here's the marking on the treated board
Best Answer
Yes, there are grading rules and tolerances for lumber, timbers, etc.
You are describing "dimensional lumber". Grading rules for that (especially where you live) is established by the American Softwood Lumber Association, PS-20. (Product Standard 20.)
If you look at Table 3, "Dimensional" you'll see for 2 x 10's, the minimum size is 9 1/2" for green and 9 1/4" for dry. (This can vary somewhat based on the species.) ...but the minimum size is 9 1/4".
Where I live, grading is primarily done by Western Wood Product Association. If you look on your joists, you'll see a black ink "Grade Stamp". I suspect you'll find several numbers and letters in a small grouping (about 1"x2" area) with one of the icons of WWPA. Next to that round icon, you'll see the "moisture" grade. If it reads GRN, then it was milled (cut at the mill) when it was green and had more than 19% moisture content. If it reads DRY, then it was milled when it was less than 15% moisture content. (There is a seldom used mark of S-DRY, which stands for Surface Dry and had a moisture content between 15%-19%.) Actually, if the stamp is smeared and "out of focus" to the point you can't read it, then it was milled "green".
I explained all that to let you know that your lumber could have been milled "green", but dried out, which caused the lumber to shrink.
If you read the text, you'll see that there is a tolerance of 1/4" in the width and 1/16" in the thickness...the 2x direction.
Also, the lumber could have been mis-cut and was rejected, so you won't find any grade stamp on your joists. The contractor could have bought the joists at a discount and was never caught by the Building Inspector.
By the way, the grain of wood in your picture indicates a better than a normal piece of lumber. If all the joists are similar, then I'd feel comfortable that it's structurally sound and would equal other lumber that is 1/4" larger.