garage-door-openertroubleshooting
My Quantum 3213 garage door opener only clicks when I hit the main button in the garage. The light comes on for 30 seconds or so, and then it blinks on and off.
I've checked all the safety mechanisms: the eyes are aligned, etc.
Why won't it do its thing?
I purchased a Chamberlain KLIK1U 2 button universal garage door remote a little while back and remember there being a dip switch option. I'm not sure if you can program two dip switch openers to it, but it might be worth a try.
Another option which is the one I had to do is that if you have a button inside the garage that you press to open the door, you can get a pair of Chamberlain 955D receivers. It allows you to use a rolling code remote on the opener. If you used one for each opener, you could get one remote with several buttons and program it.
I hope this helps!
I fixed the exact same problem with my garage door using a general purpose relay output wireless transmitter / receiver module I purchased from eBay. The receiver module for inside the garage operates from a +12VDC power supply which I purchased for low cost from Goodwill. The normally open relay contact of the receiver is wired in across the same wire pair used by the inside door open push button. The existing push button is designed to short across the two wires that run to the garage door opener. The added relay connections need to be wired in parallel to the switch so that they short across the same wires when the remote is activated.
The trigger buttons are small key fob type push button controls that operate from a standard type of coin battery.
Note that models on eBay change often and it is a good idea to search for a unit that comes with multiple fobs and to purchase a spare unit if you ever think you will need replacements. Some sellers will add additional fobs to your order for an additional small charge. The search to use on eBay is Wireless Remote Control.
The whole setup cost me about a third of the lower priced options that you have linked to. The unit I purchased was a two channel device with an A and B button on the fob and so one setup was deployed to run both of my garage door openers.
These come with the remote transmit code set to some default value and it is advisable to change that code to some random code that you select. Changing the code entails some work with a small electronics soldering iron inside both the receiver and the transmitter.
Best Answer
Check that the door is not unhooked from the lift mechanism. On some door systems there is a rope that when pulled releases the door from the motorized lift. This would allow the door to be opened and closed by hand. If the door wasn't reconnected to the catch then the motor when activated would spin and not lift the door.