Recently the gas company replaced our meter and thermocouple. After they left, the pilot light kept going out randomly. 4 techs came over a 3 day period and could not diagnose except to reassure that the meter and thermocouple were working fine. Then HVAC man came and found lose wires on the gas control valve, apparently knocked lose by the gas co tech. Furnace will cycle perfectly and pilot stays on as long as the thermostat temp is maintained at the same temp, but whenever I bump the temp up a couple of degrees, the pilot goes out either during the cycle or upon shut off.
Why does the nat gas furnace pilot light stay lit at normat temp setting, but goes out when I bump the temp up a couple degrees
hvacnatural-gaspilot-light
Related Topic
- Why does the pilot light go out when I release the pilot light knob
- Water – Why does the gas water heater’s pilot light go out when I replace the outer door
- Water heater pilot light always goes out during the night
- Water – I ran out of propane and now the water heater pilot light will not stay lit
- Gas fireplace pilot light goes out when fire turns off
Best Answer
This is a tough one without being there to see it.... The only thing that I can come up with is that you have a 2 stage or modulating gas valve and that when you have your thermostat set at a constant temperature your furnace is only operating on the 1st stage gas flow, but when you bump the setpoint on your thermostat up to a higher setting then the 2nd stage or higher modulation is called for and therefor a higher gas pressure is admitted to the main burners. This second stage pressure may be set incorrectly (too high) and causing the pilot flame to be pulled away from the thermocouple during the heating cycle which will cause the pilot thermocouple to cool off enough to cause the pilot safety to shut down the main gas valve and pilot burner. One other thing could be that if you do have a 2 stage or modulating gas valve and the main burner is shut off before the gas pressure is stepped down to the first stage then the sudden main burner shut down could cause turbulence and be snuffing out the pilot at the end of the cycle. This shut down could be from numerous things like a high temperature limit or other safety device shutting down the main burner while it is in the higher stage burn.