Trying to attach a c-wire to old rheem air handler for a cooling system only. System is so old I didn't see what I thought I'd see when I got up into the attic. In going over the pictures I think I might have figured it out but could use confirmation.
There's a 4 conductor thermostat wire going from the thermostat up to the air handler. Only 3 wires were used I was hoping to attach the blue wire as the C-wire.
Red Rc on thermostat
White (or maybe yellow) Y on Thermostat
Green G on Thermostat.
There's also a second 2 conductor thermostat looking cable (brown jacket) with a white and red wires.
On top of the air handler is a switch (regular light switch) I guess as a quick disconnect.
This is the wiring diagram I found inside the air handler wiring box.
There's a block that's obviously the line voltage terminal that I didn't take a picture of.
I think this is the MIB? (Motor, indoor blower)
And this RM? (Relay, blower motor) with the transformer on the right.
I think I can connect the C-wire to the yellow wire that comes off the left of the transformer or the blue wire it attaches to on the top right of the relay. Easiest is probably to cut the yellow wire and splice the 2 new ends of the yellow wire together with the blue wire from the thermostat cable. Does that sound right?
And out of curiousity what could the other 2 wire cable be going to? It's not to another thermostat.
Best Answer
This is easier than it looks even
Simply nut the blue wire in the four-wire cable to the junction of the white wire from the two-wire cable and the brown? wire going into the air handler. We know it's your C wire because that two-wire cable has only one place it can head: to your outdoor unit and its contactor. Since the red wire in that cable is the Y wire that switches the contactor, the white wire, and by extension the wire connected to it, must be C wires otherwise the contactor would never work.