I have a new whirlpool dbl oven with a 4 wire wiring harness-white, black, red and green. My old single oven compartments junction box (house was built in '79), has 3 wires-black, white, and copper ground. 50amp, 240v circuit. How do I correctly connect these?
Wiring – How to connect a 4-wire oven to a 3-wire outlet
ovenwiring
Related Topic
- Wiring – How to connect the new Fagor wall oven to the existing wiring
- Electrical – Hard wiring a 4-wire oven to 3-wire outlet
- Electrical – 3-Wire 30A needs to be 4-wire 30A for new oven, can I run a ground from wall outlet
- Wiring – How to wire / connect a new ceiling light to this ceiling junction box
- Wiring – new 4-wire GE single-wall oven jts5000snss going into grandfathered 3-wire wall junction
- Wiring – Correct wirenut
- Electrical – How to connect 3-wire appliance to 4-wire junction box
Best Answer
You'd have to look at the old receptacle to be sure. If it's a NEMA 10-50, then the following is true: it is being fed by common 6/2 grounded cable.
NEMA 10 is an obsolete and somewhat dangerous receptacle family, used in the old days for ranges and dryers. It provides hot, hot and neutral - 240V hot-to-hot, and 120V hot-to-neutral. It does not provide ground.
Often, this was installed using the common "/2" cable. There's no choice to color; it's always black, white and bare. In this usage, the white is not a neutral; it's the other hot. The bare wire is the neutral. Really.
Today, a white wire used as a "hot" must be marked with tape. Back in the old days, that was not required if the usage was obvious.
I would make the argument that the old circuit is "grandfathered", which it is. If the 10-50 receptacle broke, you could change it without breaking the grandfathering; in fact the stores sell 10-50R's for only that purpose. I would argue the same is true for changing it to a modern 4-prong NEMA 14-50. I would then use the NEC 2014 rules which allow retrofitting a true ground. Can't promise you the inspector would agree.