I have a new home with a ceiling fan with light kit installed in the living room.
The Fan and light are controlled by a remote control, but there are 2 wall switches in a double gang box that ultimately control power to the fan/light.
I'm guessing the original idea of having 2 switches wired was to allow one to control the fan and one to control the lights, and this setup
was not needed when they installed a fan/light combo that used a remote control.
Whats befuddling to me is why it's wired so that both switches control power to the fan/light unit, i.e. if the fan/light is off, either switch will provide power to unit.
Looks like a 2 conductor (black & white) wire enter the bottom of the box, and a 3 conductor (Black, White & Red) wire enters the top of the box.
Both switches are pigtailed to the the black line/hot wire and the line & load side neutrals are connected. Switch 1 is then connected to the load side
black wire & Switch 2 is connected to the load side red. All grounds are connected.
Is this correct wiring, and if so, is it a common practice?
What would I need to do if I wanted to replace the two switches with a wireless enabled in-wall switch so that only it provides power to the unit – disconnect switch 2 and cap its current load side red wire?
Best Answer
I believe you are correct in assuming that one switch controlled the fan and one controlled the lights originally.
My guess is that the wiring at the fan just has both the red and black wires connected to the line side of the wireless receiver, which would let either switch turn the fan/light on.
I would look at the wiring at the fan to confirm this. If I am correct, then yes, you should be able to disconnect the red wire. I would disconnect it from the fan and from the switch in the box and cap both ends.