drainplumbingsinkwiring
I'm removing a busted garbage disposal from under the sink and replacing it with straight pipe. I think I can manage this part of the job, but I don't know what to do with the wire. I mean the wire that was hardwired to the garbage disposal. It comes out of a hole in the back of the under-sink cabinet.
Thanks for any help,
Derek
Have a look at the trap under your sink. Assuming it's PVC with large plastic nuts, all you should need is ChannelLock pliers:
Unscrew the trap from the wall and disposal, and clean the trap itself, or snake the drain going into the wall, depending on where your clog is. Be sure to have a bucket and towels handy since there will be water backed up before the clog and in the trap.
If you can't find the clog either in the trap or with the snake, and you know it's further down the drain (try running some water through the disposal and into the bucket with the trap out), then I have family that swear by these drain bladders that attach to a garden hose, get inserted into the drain (past the vent) and they swell up to seal your end of the pipe while sending water down until the clog is forced out:
Each one of these will cost around $20 give or take, well less than a visit from a plumber.
Any of those options will work, let me reorder them to:
Now they're in order of ease and how temporary you want. If you want to simply stop the sewage fumes, the P-Trap (filled with water) will do just that so #1 & #2 will do that. #2 & #3 are good but might be a bit overkill especially if you leave the sink in place, even with the sink faucet off you'll have the occasional pot drained/strained in the sink and glass dumped in there. So if you have any drainage left, I'd just leave it and probably just turn off the faucets. If not, personally I'd removed the P-Trap back and cap it, then put a 5-gallon bucket under there.
Best Answer
Just terminate it in a junction box with a blank cover
Simply attach a junction box (a "handy box" with the appropriate cable clamp will do) to a nearby piece of cabinet frame, then terminate the cable into the box via the cableclamp, land the bare wire on the ground screw in the box, and terminate the remaining wires individually with wirenuts. Finish this off with a blank box cover, turn the circuit back on, and you're done!