I am trying to rewire the telephone wires in my home, and I appear to be not getting it. I have extremely familiar with running cat5, as I use it all day long for my job, and thought telephoney was just as straight forward.
I have standard 4 wire telephone wire. It's got yellow, green, red, and black. On one end, I have a punch down terminal inside the wall in a wall plate. That side is wired correctly, according to the keystone diagram. I actually have two of these coming from two different rooms. I then combine them both into one using a splitter like this:
That goes directly into my comcast business modem/phone. I have a cable checker that I use for my coax and rj45 connections, and it also has voice testing, too. When I check any of the cables, it shows up as open on all wires, and I can't figure out why.
I thought the wires needed to be the same all the way through, but in looking at how the wire is bundled, that doesn't seem possible. Putting the connector on both ends, then comparing the ends shows that the two inside wires are reversed. (One end is yellow, green, red, black, the other is yellow, red, green, black). I have tried remaking all the wires all the way through the line and cannot get the line to work. Even testing with a phone shows that the line is in use.
What am I doing wrong?
Best Answer
First of all, you don't need special telephone wire. You can use the same wire you use for networking - e.g., Cat 5, Cat 5e, etc. I used to use leftover old Cat 3 for telephone wiring, but once I went through all that, I switched to using Cat 5 for everything even if it costs a little extra for the phone wiring than absolutely necessary.
Telephone wiring does have polarity - i.e., red/green is different from green/red. But it does NOT usually matter.
The middle pair on T568A/B wiring is the same as the pair (aka red/green) for standard phone wiring. You should use RJ11 (1 pair = 1 phone line) or RJ14 (2 pair = 2 phone lines), but you can actually use RJ45 network jacks and just connect a pair to pins 4/5 for one phone line, though the patch cables may not hold as well as with RJ11/RJ12.
Troubleshooting: Ideally you should have three tools to test:
Just work through it step-by-step. First check the Comcast modem and make sure a phone (or test set) works there. Then put in the splitter and make sure each connection works there. Then put in the next patch cable and check there, then the long cable run to another room, then its patch cable, etc. At each step if you can't see the problem then use the wiring tester to see what, if any, wires are actually connected.
I also recommend NOT using a long cable with plugs on the ends. Wire up (same for Ethernet) jacks on each end and use short, easily/cheaply replaceable, pre-made patch cables for jack-phone, jack-splitter, etc. Properly installed jacks rarely go bad, but plugs on the end of long cables often go bad.