I think the answer would really depend on the flexibility of the bar top. You could test the flexion of the board with a jig, and if it's up to muster, then the only other concern is the back corner. That is where the force on the outer corner is going to transfer to, in an upward manner. You mentioned that the angle iron is going into 2"x6"s, so those should be fine.
If the grain of the butcher board runs lengthways, I would stick with the threaded rod, but if it runs the short way, you might run into compression/differential problems with the glue joints.
It's a very smooth idea, I hop you can make it work!
It sounds like you have a very sensible and thorough approach to the project. Just a few suggestions:
Saw Blade
Most blades that come with table and miter saws are fairly low end. If you are cutting plywood for finish carpentry, you want a high tooth count blade for smooth cuts. Check out one of the blade manufacturers for the range and you will find some recommended for this type of work. The cost is worth it and it will last through many more projects.
Angle cuts
This is where your cut-twice idea is a good idea. You are just trying to replicate a given angle. Measure the angles either with a protractor, or, if the piece being matched is an angle cut across a short dimension (rather than a long bevel) lay it up against the angled saw blade to check.
Use scrap wood to make a try cut angle based on your best estimate. If it is off, adjust the blade or angle guide slightly and try again. When you have the exact angle, cut the good wood.
If you need to make an angle cut on a wide board on the table saw, consider an adjustable taper guide that runs along the fence.
Materials
It wasn't clear to me whether you were going to make the face frames out of pine or just make mock ups and then use oak. For the actual frames, use oak. It is both more rigid and much less prone to seasonal change. All woods shrink and swell somewhat, even when well sealed, but softwoods much more so. You could find shifting of doors and binding drawers if you use a wood that changes much.
Cutting on/next to marking lines
It doesn't matter. What does matter is consistency. You need to know where your mark is in relation to the exact measurement, and cut accordingly. And do the same thing every time.
For example, if you measure a board using a rigid rule, and you mark with a pencil, you can have the far edge of the pencil line at the exact distance. The thickness of the line is within the length you want. Then make a line across the board using a square at the exact spot. Many woodworkers use a scribing tool instead of a pencil to get a finer marking. In this case, you would cut leaving the line behind, since it was within the length you wanted.
Also realize that when your finished cabinet meets other surfaces, such as the wall, it will almost never be an exact fit, due to slight irregularities in angle and levelness of the wall. This is where trim strips come in. While there is a technique for scribing an exact contour to fit a cabinet to a wall, that is a bit more challenging. Unless you are going to do that type of trimming, leaving a cabinet a hair shallow or short is much better than too deep or too high. Shims and trim work wonders.
Best Answer
A narrow slab door might fit the bill. 80" is a very common height. Architectural recycling places, such as Habitat For Humanity Restores (if you're in North America) have them for nearly nothing. If you get a hollow core and it's too wide, be aware that it's a bit fiddly to make it work well.