Wood – How to go about leveling out streak marks in the wood stain

Pine is a difficult wood to stain under the best of situations. Pine has areas of different density, color, and resin (pitch) content. Using a product like Minwax prestain helps a bit. Follow the timing instructions carefully when using a pre-treatment. Little tips: i like to apply a liberal coat of oil based stain with a sponge brush. Let it set a few minutes, then rub it in and evenly distribute with a lint free rag. As one rag becomes saturated with stain, I use a second drier rag to finish the rub in. The wetter rag is great for distributing the color. You don't want any really wet stain remaining on your wood after the rub in. Once you get to the urethane, sand lightly between each coat with 220 grit paper to remove any dust bumps. Remove all sanding dust with a slightly damp cloth, let it dry and apply next coat. Again, I prefer a good grade sponge brush, but a good grade regular brush for oil/urethane works good for appling the urethane. Remember, thin coats, and sand between each coat.

Staining will highlight any imperfections in the wood. From the photo it looks like something has been wiped across the grain. That could be when you wiped the sawdust away or possibly if you wiped the stain across the grain.

Having a good surface to stain is pretty much essential as the stain will highlight even the smallest imperfections.

Applying thin coats as John suggests is the best way.

Also, don't forget that the wood will age - especially for something left outside - so any imperfections you see now will blend over time.