Wood – How to shorten or replace this cabinet door

cabinetscarpentrycustom-cabinetrywoodworking

I disassembled the cabinet over my fridge and shortened it to fit a taller fridge. It turned out well, about 4 inches shorter than before. But I'm at a loss about what to do with the two doors. I figured it would be easy to get them shortened, but it hasn't been.

Cabinet contractors I've contacted around me mostly only work with one brand and only want to do big jobs. I'm not ready to replace all of the doors right now.

One handyman said he could get it done but eventually gave up and returned them to me.

I've searched the other cabinets and can't find the manufacturer sticker, so I don't know who makes them. The sticker is probably painted over. Otherwise I'd just order a replacement.

I might be able to do it myself if I go to a shared woodshop with a router, but I'm afraid of messing them up, so I'd prefer to have them shortened professionally.

How would you go about shortening or replacing these two doors?

Are there vendors online who could do this kind of custom job and I could ship them the doors?

too tall..

Best Answer

How would you go about shortening or replacing these two doors?

I'd only attempt this if

  • The door was to be shortened by more then the maximum width of the top rail.
  • I could find router bits that give a reasonable match to existing profiles.
  • I had a plan B in case I wreck the door.

I would cut the top off at the new height and see if the panel is loose or glued. In my kitchen the panels are loose and retained by slots in the rails and stiles. If loose I would remove the panel to cut the new arch in it. I would hope to use the cut-off top as a template.

I would then try to salvage the rail from the cut-off top. You only need to preserve the visible front edges, so you can be reasonably creative about how you remove the tops of the stiles. Ideally you'd find a router bit of the required profile but lacking that, some careful work with chisel or rotary tool might succeed.

Then its a matter of working out some new way to rejoin the rail to the stiles. You could probably use through-dowels or screws from the sides

Then I'd use a router bit to re-cut the top profile. Worst case is to grind an old chisel to match the profile and insert that into a block of pine to make a moulding plane for the job.

Finally I'd use filler where needed at the back, sand smooth and repaint.

You have to ask yourself if it is worth the effort.

Related Topic