Hi it is the first time for me to woodwork.. I would like to know which is the best and resistant wood to built a patio set. I'd like two chairs, small table and umbrella.
Wood – which is the best wood for a patio set
woodworking
Related Solutions
I will show how to build a simple A-frame swingset from pressure-treated four-by-fours and scraps, with minimal cutting.
From a six-inch-wide pressure-treated board (e.g., a 5/4-inch by 6 inch deck board), cut four isosceles trapezoids with bases that are 11 and 16 inches.
Take two legs (8-foot-long 4x4s) and align them with the legs of one of the trapezoid while touching each other on the top. Draw a line across the 4x4 legs along the short base (top) of the trapezoid. These lines are for alignment, not for cutting.
Center a scrap block of 4x4 above the trapezoid and draw lines on the legs along the sides of the block. Cut the legs along these lines.
Attach the trapezoid with screws. Attach a second trapezoid on the other side of the legs.
About six inches below the trapezoid, attach a crossbar made from another piece of 5/4x6 board. You could also use a 2x4.
Make a brace from 2x4 or 4x4. (Measure from the top of the trapezoid to the bottom of the crossbar and apply the pythagorean theorem to get the length of the brace.) Cut at 45-degree angles and attach to the crossbar.
Repeat steps 1–6 for the other A.
Assemble. Here's how to do it by yourself:
Hang swings and enjoy!
- Put the table/chair on a very flat and very horizontal surface. Ensure and double check with a levelgauge.
- shim the table/chair so that the top surface of the table/chair is level using the level gauge
- Take a pencil and tape it on a small block that is about the height you want the legs to shorten. Ensure that the block has parallel bottom and top planes.
- With the pencil on the block, scribe the legs of the table/chair and make marks all around.
- Cut precisely and carefully with a proper saw. Which is probably the hard part. If you start on a corner of a (square) table leg, make sure you cut on the cutting line on two faces.
in short:
Watch this video by Chris Schwarz: level the feet of a chair or sawbench
Related Topic
- Wood – the best tool for cutting up scrap wood
- Wood – Which technique of wood joining is the best for joining these boards of a small table
- Wood – what is the woodworking technique used to build this piece
- Wood – Reinforce chair stretchers with screws
- Wood – What types of tools are required for making wood toys and models
- Wood – How to make wood slats of slightly different lengths, all of the same length
- Wood – What’s the best way to create a wood elbow
- Wood – How to bend stair rails
Best Answer
Redwood, cedar, and teak are probably the most common rot-resistant species used for outdoor furniture. The first two are a pleasure to work with, but they're very soft. That means that they can be damaged more easily. Teak tends to be less common and/or more expensive.
Pine (or spruce or fir) is inexpensive and can actually last quite some time if properly sealed and not left in consistently damp environments.