Minecraft – Prevent spider spawning in a Mob trap (Minecraft 1.3)

I know that this question was asked a long time ago, but just thought I'd give an update and a correction for future people that read this. (please consider that things may also change in future)

Ok, so first of all, you mentioned that a Chunk is 16x16 block around the player. This is incorrect. A chunk is a section of the terrain and is nothing to do with where the player is. The chunk does not move. A chunk is a 16x16x256 (W,D,H). So for the mob spawning. The quote you gave is correct, however, does not note that it is centred around the chunk that the player is standing on. So 7 chunks in every direction from the border of the chunk you are standing in.

And now for your question :) Recently, (not sure when it started) height has become even more important for mob spawning and each chunk is split into segments. This is to reduce the amount the game has to render and does this by going up in 16 block segments starting from 1. So 17, 33, 49, etc. This is called the lc value and can be shown on the debug screen (F3). It is important for mob spawning, why? Because any segments in the chunk above the maximum segment that has anything other than air in do not get checked for spawning conditions. This therefore means that there are many less blocks to check which in theory will make your mob grinder or xp farm more efficient.

There is a fair amount more... however, I think this answers what you wanted. At least I hope it does ;) Best of luck guys.

First, take note of some information about light-emitting blocks from the Minecraft wiki:

• Torches have a light level of 14, while glowstone has a slightly higher light level of 15.
• The light emitted decreases by one for each square of distance from the light source.

This means that if you wanted to light up a horizontal line of blocks such that the light level was 8 or higher everywhere on the line (to prevent most hostile mob spawning), you could place torches along the line with 12 blocks between them, or glowstone blocks along the line with 14 blocks between them.

Now, moving vertically will decrease the amount of light as well, also by one for each block moved. This would mean that if you moved 3 blocks horizontally, then 3 blocks vertically from a torch, the light level will drop by 6 to a value of 8. So, you could just count the number of blocks you have moved both horizontally and vertically from a source to figure out what the light level has dropped to and when you need to place another light source. I believe once you reach a count of N-1 blocks from the light source (where N is the light level of the source) is when you should place another one.

A potentially easier alternative to counting is to use the debug screen (press F3) to track light levels. This will show you a bunch of stats, like so:

The number to pay attention to is the one I circled labeled "bl", which stands for block light. This is the light level due to sources other than the sun and the moon as measured at your head level. This means that if you place a torch on the ground, then stand in the same spot, you will get bl = 13, since your head is one block above the light source.

Using this may make it easier for you to lay out your light sources and to check where you may have some dark spots. I use it often inside my structures to make sure I have lit them up appropriately.