What does watt specify in induction stove

A regular electric oven uses a large coiled resistor as a heating element. A large electric current is passed through this element which generates heat, similar to the tungsten filament of an incandescent light bulb.

An induction stove doesn't actually generate heat itself, but rather induces it the pot or pan. It does this using a rapidly oscillating magnetic field. This field induces an electric current in a ferromagnetic pan which generates heat, thus heating the food.

Induction stoves are faster, safer, and more energy efficient than traditional electric stoves. It requires significantly less electricity to create the magnetic field than it does to drive enough current through a resistor to make it heat up. They are safer because they don't actually generate heat themselves. After taking a pot off the "burner" (glass surface) it quickly begins to cool.

With regards to differences in the cooking process, there's not much. You just need to be aware that it heats up much more quickly and cools down much more quickly than a traditional electric stove. It does affect your choice of pans however. All aluminum pans will not work, nor will some lower quality stainless steel ones. If a magnet sticks to the pan then it will work just fine. The pan must also have a flat bottom to make full contact with the surface.

Induction just heats the pan using magnetism. Aside from very high efficiency, it isn't so different from any other method, and how hot the oil gets is an issue of power output and heat transfer/conductivity of the pan itself. There isn't an appreciable difference in how the physics work inside the pan.

Clearly your oil is not hot enough for frying/sautéeing. Most induction cooktops say they draw at least 1000 W to produce temperatures in the 350-400° F range, which is a somewhat typical frying temperature, being just at or below the smoke points of most oils. However, that number is based on a lot of assumptions, and 1500 W is not necessarily a generous margin of error for a portable hot plate. A lot of things could prevent you from reaching even a modest 400° F:

• The pan is too dense. Are you using cast iron? It responds well to induction but the thermal resistance is also a lot higher.

• The pan is very large and/or you're stuffing a lot of food into it, a result of which could be that the heat is escaping faster than the hot plate can pump it out.

• The pan does not actually have the right amount of magnetic permeability for high-heat cooking. A magnet may stick to it, but how hard does it stick? If there isn't a very strong attraction - i.e. you have to put some effort into pulling off a permanent magnet - then you're not getting anywhere near the efficiency the unit was designed for, and even the full 1500 W may not be enough to reach the desired temperatures.

• The cooktop is not really pulling in the full 1500 W, either due to a poor power source or simply poor design. Some manufacturers might quote 1500 W as a peak in order to sell more units, knowing full well that they can't sustain more than about 60% of that. If you've got a power meter (e.g. Kill-A-Watt), plug it in and see how much it's really drawing.

There are some portable induction cookers that go up to 1800 or even 2000 W, which is the bare minimum for the large element on an electric or induction stove (2500 W is typical for those). If you want to use a portable hot plate for high-heat cooking, check your pans very carefully, don't overcrowd them, and if all else fails, you might just need a better hot plate.