I'm framing out my basement, which I've done once before in an old house. I use the treated wood (green board?) for the bottom plate, raise up the frames, get everything level, and use cut nails to attach into the concrete.
But for framing out doors, where I want to have the door close to the beginning of the wall, I need to somehow put multiple nails through a 5 or 6 inch piece of green board, and I don't have any room with the king studs and jack studs, to do it after I build the frame, but I don't want to toenail, either, makes keeping it plumb difficult.
More importantly, when I tried this once already, I split the green board. Should I just attach the frame real well to the perpendicular wall and not worry about it? Should I liquid nails the bottom plate to the concrete? Both?
Best Answer
You could run your PT plates across the doorway to begin with, then cut them out after the fact. (Predrill the plate and use tapcon style screws and you won't split even a short bit of plate.) The upside of this is that you'll have a straight line across the doorway. Build a wall on this with another bottom plate/studs/top plate and it's easy to plumb it.
Alternately, you could skip the plate and attach the framing to the wall, but that could have issues with the lumber running nice and straight in line with your opening. Best practices would have you use pressure treated lumber in contact with concrete. (It's a bit of a waste of lumber to have 4 or 5-2x4s stacked up where you don't need them. Plus you'll have a hard time putting a light switch there.)