2×6 construction, exterior load bearing walls.
Recently started trying to splice long walls with the end stud landing half on first wall plate and half on second wall plate so the stud joining the two plates has 3/4" bearing on each end. I end nail the one wall with the stud then stand the second wall, tap it into the splicing stud, and toenail that one.
Now say a 16' wall plate ends roughly center of a window or door that will have a header, and cripples/jacks if it's a window. Is this kosher? How do you join the top plate if it's it a door and bottom plate if it's a window? I can't see standing the wall with half the header sticking out flopping in the breeze (it won't flop but it will only be supported by the one side of the king stud and trimmer) this seems like a bad idea.
Is there an efficient way to frame where you stop a wall plate before the window or door? I don't see a way around the other system here where you double down on your studs and nail those two studs together to splice the wall and maintain full strength but narrow up the stud cavity space.
Best Answer
You mentioned the obvious solution in your question. Just build the wall in different segment lengths to avoid windows and doors.
Another option is to simply set the head er after the two wall segments are stood up.
Don't overthink it. Just do what seems convenient at the time. All the pieces end up in the same places anyway.