I have a guesthouse with an unusual door, 32" x 76", and it needs a screen door.
Home Depot has tons of cheap-o screen doors that could be cut down to maybe 32" x 78" safely, but an additional two inches will probably cost my screen door structural integrity.
I've thought about building a screen door, but — well, I lack some of the tools I think I'd need, namely: a planer, a joiner, and mortise and tenon jigs. I have a table saw, but it's disassembled and I have no where to actually run it. I do have a circular saw, a router, a jigsaw, a miter saw (chop saw), and a hand drill (all electric).
I could order a custom screen door for $250-300, but I can't believe there isn't a less expensive solution out there. I spent $300 for the door itself — and can't believe I should have to spend another $300 just for a screen door.
Most of the plans I've found on the net require tools I don't have, and are overly complicated for my guesthouse's needs.
Here are a couple of possibilities, and I'd really love your feedback:
- Could I accomplish what I want with just some pegs and maybe a couple of L-brackets? Or will that be too weak with the constant slamming of the door?
- Is there a simple way to construct a mortise and tenon jig that would enable me to use only my router and maybe a drill for this project?
- Am I missing some other obvious option?
Where are you when I need you, MacGyver? ("macgyver" should really be a tag here on diy.)
Best Answer
Personally, I'd get the table saw a portable folding stand, you can do basically everything you need with the tablesaw and can build any of the jigs you need.
You could also do most of the work with your circ saw and router but getting the wood to the correct dimensions is going to be easier with a table saw since you don't have a planer or jointer.
Instead of mortise and tenon, look at doing half laps for the corner joints and for a support brace or two across the middle. You can probably get some nice looking metal braces to strengthen up the corners as well. You should be able to do half laps using your circ saw or router. You can also profile all the edges with the router to making look nice.