Smart switches are not equal partners like old style 3-way switches. They are "master" and "remote".
This model of smart switch is a "master" and requires certain models of "remote" which require "neutral" (white wire) to be present in both switch boxes. That is not always so, as the electrical code only recently started requiring it.
So I'd first check the other box - if there's no neutral in it, you cannot wire a remote (though wireless options may exist). Useless old work can be dangerous, so tidy up by removing the 3-way switch, wire-nut the common to one of the messengers (trial and error will reveal which), cap the other one off, and put a blank wall plate over the hole.
If a white wire is already wired to a terminal on the old 3-way switch, bad news - that is NOT a neutral, but one of the messengers (the two inter-switch wires). Before the code change, they often used common 14/2 Romex for messenger, and one of the wires is white. They're supposed to paint or tape it.
If there is a neutral in both boxes, you can wire a remote. First, figure out which box is upstream (closest to the service panel aka breaker box). It will contain a wire that is always hot - regardless of the position of any switch.
Then review the diagram (which you already linked) showing you the wiring scheme for whichever remote you bought. You will need to re-use both of the old messenger wires.
What you're after requires a whole new wire to the fan: You currently have a single hot wire going to the fan, that supplies power to both the light and fan. You want to be able to split that out, so you'll need an additional hot feed, one for the fan, one for the light. So leave the three way switches as they are and get a qualified electrician to install a new 14/2 conductor from one of the switchboxes up to the light fixture.
You'll either need to install a double switch or expand the switchbox in order to make room for the third switch.
Best Answer
Turn off all power before starting any work. OK switch B can remain in place but you have to determine which of the two orange travelers is hot when switch B is in the top (ON) position, then disconnect and tape the other orange wire. Remove switch A and wire nut the yellow wire to the hot orange that you did not disconnect from the other switch. Tape the other orange. You'll need to get the correct cover plate for switch A to cover up the unused gang.
It's always a good idea to put a note in each of the two boxes you worked in describing what you did for future reference. It might just help you, or a new owner, in the future.