Lighting – do to avoid incandescent bulbs for the 3-bulb ceiling fan, yet maintain brightness

bulbceiling-fanledlighting

My ceiling fan takes 3 candelabra (E12) base bulbs for lighting. The bulb slots are labeled 75W – 125V. The fan light is dimmable and I currently use 3 60w incandescent flame tips.

I plan to switch to LEDs or flourescent bulbs, but so far I have only found candelabra-based LED bulbs at 25w equivalent. Even with 3 of them, the room is not as bright as I want it, especially considering the previous lighting set-up.

What can I do to make the lighting situation brighter, understanding the 75W / 125V constraints, and that I would like the potential to use the dimmer ability?

NOTE: User "Monso" responded in the comments about using an adapter like this one to allow for larger bulbs to be used, and while that seems like a good solution (bigger bulbs = brighter bulbs), I want to make sure I don't overload the circuitry. Am I still constrained to 75w / 125v with the larger adapter? What are my limits if I wanted to use an LED or florescent bulb?

Best Answer

Do you have the space for an adapter like this one?

enter image description here

Lighting EVER Candelabra Screw (E12) to Medium Screw (E26) Enlarger Light Bulb Socket Adapter

Q: I'm going to overload it by using a larger bulb ?

A:

  • Electrically you are limited to the maximum amperage that the wiring will support, if it is rated for a 75W 125V then that's 0.6 Amps each (Wattage = Voltage * Amperage). You're not changing the voltage or number of lamp so it doesn't quite matter (doing the numbers that is). You can do up to the same amount of actual Wattage used, which for LEDs would be significantly less.

  • Heatwise, the LEDs should produce significantly less heat than incandescent, just make sure you have at least 1/8" between the LED's bulb and the shade/globe/etc and you should be alright; incandescent should be more like >1/2".

  • CFL Side Note The same electricity rules apply for CFLs (or anything, note CFLs do have a peak turning on but I doubt you'll find a 75 actual Wattage CFL to fit), but I'd increase the minimum gap for heat to about the same as in incandescent ~1/2". I've had a few cheaper lamps with CFLs burn/melt so I'm a little over cautious with CFL and proximity even though they should produce less heat than their incandescent Lumen- relative counterpart.

Q: The bulbs will be put in sideways; I hear many LED bulbs are unidirectional; what degree/angle should I be looking for?

A: For unidirectional light, you probably need to find one with a diffuser or multiple LEDs pointing in different directions. If you can see the individual LED(s), it will shine light in the opposite direction(s) it/they are mounted only so if they all point in the same direction it's unidirectional. If you can't see the individual LED(s) then it is probably diffused (though it may not be diffused well)

Related Topic