Is there any way to create an floodgate that would be open and it will close when it is triggered (by a pressure plate)?
I made an image to properly show the position of pressure plate.
(assumed) working :-
- when the block near the river is channeled water will flow through a channel to ramp shown in figure.
- the water will flow from ramp (at right) to left.
- the floodgate should remain open for the water to flow to left.
- when the water will reach to the tile which will contain pressure plate, (the pressure plate is water triggered) the pressure plate will trigger and close the flood gate.
Now I want to ask: is it possible to make the flood gate normally open so water is able to flow to the pressure plate and after reaching the pressure plate floodgate will close?
Best Answer
If a floodgate in specific is not required, I will often use a bridge for this purpose. If you build a 1x1 bridge and tell it to raise rather than retracting, then when triggered it will be impassible.
There are several other advantages to using raising bridges:
If you link one trigger (such as a lever or pressure plate) to both a bridge and a flood gate then they will remain in opposite states of obstruction. (The flood gate will be open while the bridge is closed and visa versa.) Of course really fast state changes can mess this sort of thing up.
If you need to block a stretch larger than one tile, then you can build a longer bridge to block it. Just be sure to make it raise the correct direction (one of the directions along the pathway), or it won't block things effectively. This can be faster to build, and it takes fewer resources (That precious imported bauxite in 40d).
You will never accidentally lock your construction dwarves behind an un-openable wall. Bridges are built in passable condition.
Bridges will open and close more reliably. They don't get jammed easily.